Difference between revisions of "How To - Build a VTx 12v Regulator"
From ItsQv
(Created page with "How-To<br> <i>January, 2018</i><br> <br> {| cellspacing="1" cellpadding="1" width="95%" border="0" |- | align="left" valign="bottom" width...") |
(→Components) |
||
(One intermediate revision by the same user not shown) | |||
Line 6: | Line 6: | ||
| align="left" valign="bottom" width="50%" | __TOC__ | | align="left" valign="bottom" width="50%" | __TOC__ | ||
| align="right" width="50%" | [[File:VTXPS_0.jpg|600px]] | | align="right" width="50%" | [[File:VTXPS_0.jpg|600px]] | ||
− | |||
− | |||
− | |||
|} | |} | ||
Line 17: | Line 14: | ||
=== Components === | === Components === | ||
− | The four parts I used for this are shown below: | + | The four parts I used for this are shown below:<br> |
:* <u>[https://www.readymaderc.com/store/index.php?main_page=product_info&cPath=11_66_71&products_id=4081 RMRC 1.7A LC Filter]</u> | :* <u>[https://www.readymaderc.com/store/index.php?main_page=product_info&cPath=11_66_71&products_id=4081 RMRC 1.7A LC Filter]</u> | ||
Line 24: | Line 21: | ||
:* 0.22uf/50v Ceramic Capacitor | :* 0.22uf/50v Ceramic Capacitor | ||
− | Total cost (for me) at the time of writing | + | Total cost (for me) at the time of writing was $7.22 USD.<br><br> |
=== Regulator Circuit === | === Regulator Circuit === |
Latest revision as of 01:54, 3 January 2018
Introduction
This article shows how to make a very simple and reliable linear 12v filtered regulator to power a VTx or 12v FPV camera. It uses an LC filter purchased from Ready Made RC and an LM340T 12v regulator circuit. It is very compact and will deliver 1.5A.
Components
The four parts I used for this are shown below:
- RMRC 1.7A LC Filter
- Texas Instruments LM340T-12 Regulator
- 0.1uf/50v Ceramic Capacitor
- 0.22uf/50v Ceramic Capacitor
Total cost (for me) at the time of writing was $7.22 USD.
Regulator Circuit
I pulled the regulator circuit directly from the LM340T data sheet:
Proto Board
I used a small piece of proto board to mount the four components:
Completed Unit
My completed unit has connectors for a JST battery plug, VTX servo connector and OSD servo connector.
See Also
- TBA
Vendors used for this project
- ReadyMadeRC
- Digikey
Comments? Questions?