Difference between revisions of "Prop Test - 9 and 10 inch props for FPV"
From ItsQv
Line 5: | Line 5: | ||
|- | |- | ||
| align="left" valign="bottom" width="30%" | __TOC__ | | align="left" valign="bottom" width="30%" | __TOC__ | ||
− | | align="right" width="70%" | [[File: | + | | align="right" width="70%" | [[File:Prop dwg.jpg|700px]] |
|- | |- | ||
| | | |
Latest revision as of 23:06, 19 May 2016
Contents |
|
Props! |
About this test
This test was done to compare nine and ten inch props popular on many smaller FPV planes. Three test runs were done for each prop and averaged to get stabilized results. All tests were done using a regulated power supply set to 14.8v to emulate the nominal voltage of a 4S pack. Two test protocols were followed, 1st a wide open throttle test and 2nd a low level power test. The motor used is a Cobra 2814/16-1050kv.
9 & 10 inch prop results |
See Also
TBA