Difference between revisions of "How To - Create a Kevlar Skid Shield"
(New page using form Test) |
|||
Line 1: | Line 1: | ||
− | The first time I used this method was in 2003 when I was building a Sig Models LT25 balsa model. In the instructions they show how after the wings are glued together you should put a layer of fiberglass across the seam and soak it with thin CA. I was amazed at how strong this made the wing join. | + | == Introduction == |
+ | |||
+ | The first time I used this method was in 2003 when I was building a Sig Models LT25 balsa model. In the instructions they show how after the wings are glued together you should put a layer of fiberglass across the seam and soak it with thin CA. I was amazed at how strong this made the wing join.<br><br> | ||
+ | |||
+ | Looking through RC Groups to find a better way to create a rock shield or skid plate, I found a few posts on using CA and lightweight Kevlar cloth. This article then covers what I have learned about this including a cheap way to make awesome Kevlar cloth cutters.<br><br> | ||
+ | |||
+ | === Light Cloth & Cheap Scissors === | ||
+ | |||
+ | Kevlar is really tough stuff so you don't need a heavy fabric. I have used 1.7oz and 2.5oz cloth and found that the 2.5oz is not really any tougher and adds a lot of weight. You can find small pieces of 1.7oz cloth on ebay.<br><br> | ||
+ | |||
+ | To cut the cloth you can buy special scissors or for about $2, make your own. $2 is what I paid at a "dollar" store for a pair of Fiskar scissor clones. After you get your cheap scissors, clamp them in a vice and file or grind them with a course file or grinder against the sharp edge.<br><br> | ||
+ | |||
− | |||
<br><br><br> | <br><br><br> | ||
[[Category:HowTo]] | [[Category:HowTo]] |
Revision as of 01:01, 2 February 2016
Introduction
The first time I used this method was in 2003 when I was building a Sig Models LT25 balsa model. In the instructions they show how after the wings are glued together you should put a layer of fiberglass across the seam and soak it with thin CA. I was amazed at how strong this made the wing join.
Looking through RC Groups to find a better way to create a rock shield or skid plate, I found a few posts on using CA and lightweight Kevlar cloth. This article then covers what I have learned about this including a cheap way to make awesome Kevlar cloth cutters.
Light Cloth & Cheap Scissors
Kevlar is really tough stuff so you don't need a heavy fabric. I have used 1.7oz and 2.5oz cloth and found that the 2.5oz is not really any tougher and adds a lot of weight. You can find small pieces of 1.7oz cloth on ebay.
To cut the cloth you can buy special scissors or for about $2, make your own. $2 is what I paid at a "dollar" store for a pair of Fiskar scissor clones. After you get your cheap scissors, clamp them in a vice and file or grind them with a course file or grinder against the sharp edge.