Difference between revisions of "Dynamic Motor and Prop Balancer"
From ItsQv
(→Purchase Parts) |
(→Introduction) |
||
| Line 20: | Line 20: | ||
<br> | <br> | ||
| − | Basically, this is a dynamic balancer for motors and props that can be built for under $ | + | Basically, this is a dynamic balancer for motors and props that can be built for under $100. In the original write-ups there are two versions of the control board and firmware but this build only covers the version that uses the Teensy micro-controller.<br><br> |
== Parts == | == Parts == | ||
Revision as of 23:26, 1 November 2017
|
This page or section is under construction and will change going forward.
Questions or Comments? Please contact the Wiki administrator |
© Mark Qvale - November, 2017
| |
| A new tool! |
Introduction
This project was actually done some years ago by some great posters on RCGroups and DoItYourselfDrones. You can read the original threads at these two links:
Basically, this is a dynamic balancer for motors and props that can be built for under $100. In the original write-ups there are two versions of the control board and firmware but this build only covers the version that uses the Teensy micro-controller.
Parts
Purchase Parts
- Teensy USB Board, Version 3.2
- 3-Axis ADXL345 Digital Acceleration Module
- QEE123 - Plastic Infrared Light Emitting Diode
- QSE159 - Silicon Photosensor
- 300g Gimbal cushions
- 56 ohm 1/4 watt resistor
- 100 ohm 1/4 watt resistor
- 10K ohm 1/4 watt resistor
- Standard Red LED
- 50mm x 70mm Hobby Board
- Pin Headers
Make Parts
- Photo Sensor mount
- Cushion Bases
- Balance platform
- Motor mount plate
- Teensy control board
- Wood base
|
|
|
Wiring
|
|
