Difference between revisions of "Dynamic Motor and Prop Balancer"
From ItsQv
(→Make Parts) |
(→Make Parts) |
||
| Line 64: | Line 64: | ||
|- | |- | ||
| align="center" width="70%" | [[File:Balance_Platform.jpg|700px]] | | align="center" width="70%" | [[File:Balance_Platform.jpg|700px]] | ||
| + | |} | ||
| + | <br><br> | ||
| + | |||
| + | === Wiring === | ||
| + | |||
| + | {| cellspacing="1" cellpadding="1" width="95%" border="0" | ||
| + | |- | ||
| + | | align="center" width="70%" | [[File:Balance_Wiring.jpg|700px]] | ||
|} | |} | ||
<br><br> | <br><br> | ||
Revision as of 22:58, 1 November 2017
© Mark Qvale - November, 2017
| |
| A new tool! |
Introduction
This project was actually done some years ago by some great posters on RCGroups and DoItYourselfDrones. You can read the original threads at these two links:
Basically, this is a dynamic balancer for motors and props that can be built for under $50. In the original write-ups there are two versions of the control board and firmware but this build only covers the version that uses the Teensy micro-controller.
Parts
Purchase Parts
- Teensy USB Board, Version 3.2
- 3-Axis ADXL345 Digital Acceleration Module
- QEE123 - Plastic Infrared Light Emitting Diode
- QSE159 - Silicon Photosensor
- 56 ohm 1/4 watt resistor
- 100 ohm 1/4 watt resistor
- 10K ohm 1/4 watt resistor
- 50mm x 70mm Hobby Board
- Pin Header
Make Parts
- Photo Sensor Mount
- Cushion Bases
- Balance Platform
- Motor Mount Plate
- Teensy Control Board
|
|
|
|
|
Wiring
|
|
