Difference between revisions of "Dynamic Motor and Prop Balancer"
From ItsQv
(→Parts) |
(→Parts) |
||
| Line 32: | Line 32: | ||
:* 10K ohm 1/4 watt resistor | :* 10K ohm 1/4 watt resistor | ||
:* 50mm x 70mm Hobby Board | :* 50mm x 70mm Hobby Board | ||
| − | :* Pin Header | + | :* Pin Header<br> |
| − | <br> | + | |
=== Make Parts === | === Make Parts === | ||
Revision as of 22:00, 1 November 2017
© Mark Qvale - November, 2017
| |
| A new tool! |
Introduction
This project was actually done some years ago by some great posters on RCGroups and DoItYourselfDrones. You can read the original threads at these two links:
Basically, this is a dynamic balancer for motors and props that can be built for under $50. In the original write-ups there are two versions of the control board and firmware but this build only covers the version that uses the Teensy micro-controller.
Parts
Purchase Parts
- Teensy USB Board, Version 3.2
- 3-Axis ADXL345 Digital Acceleration Module
- QEE123 - Plastic Infrared Light Emitting Diode
- QSE159 - Silicon Photosensor
- 56 ohm 1/4 watt resistor
- 100 ohm 1/4 watt resistor
- 10K ohm 1/4 watt resistor
- 50mm x 70mm Hobby Board
- Pin Header
Make Parts
- Motor Mount Plate
- Photo Sensor Mount
|
|
|
|
